Engine Performance (A8)第 110 / 120 题
A no-start with no spark and no injector pulse, but a good battery and cranking, most likely points to:
a.A worn water pump
b.A clogged cabin filter
c.A failed crankshaft position sensor or PCM/power issue
d.A leaking A/C condenser
解析
When both spark and injector pulse are absent during cranking, a shared input such as the crankshaft position sensor or a PCM power/ground problem is a prime suspect. Scan-tool rpm during cranking helps confirm the crank signal. Systematic checks of power, ground, and reference sensors isolate the cause.
免费刷完整 120 道题库 — 无需注册。
同考点相关题目
- Technician A says low fuel pressure can cause a lean misfire and hesitation. Technician B says a clogged fuel filter or weak pump can lower fuel pressure. Who is correct?
- The throttle position sensor (TPS) informs the PCM about:
- A vehicle fails an emissions test for high hydrocarbons (HC). This is most commonly associated with:
- The PCM uses the crankshaft position sensor primarily to:
- On an OBD-II vehicle, the data link connector (DLC) used to retrieve codes is standardized as a:
- The exhaust gas recirculation (EGR) system reduces which emission by lowering combustion temperature?