Installation第 29 / 110 题
When brazing refrigerant copper line sets, dry nitrogen is flowed through the tubing to accomplish what?
a.Add refrigerant charge
b.Prevent oxidation and scale formation inside the tubing
c.Increase joint temperature
d.Test the thermostat
解析
Flowing a small amount of dry nitrogen through the lines during brazing displaces oxygen and prevents the formation of copper oxide scale inside the tubing. That scale can break loose and clog metering devices or contaminate the system. This practice protects the refrigerant circuit.
免费刷完整 110 道题库 — 无需注册。
同考点相关题目
- A high-efficiency condensing furnace (Category IV) is typically vented with what material?
- Why must condensate from a condensing furnace or cooling coil be routed to an approved drain?
- A secondary condensate drain pan or float switch is typically required when an air handler is installed where?
- Refrigerant suction lines on a split system are typically insulated for what reason?
- What is the purpose of maintaining manufacturer-specified clearances to combustibles around a furnace?
- A properly installed refrigerant line set should have the liquid line and suction line sized according to what?