Systems & Code第 50 / 110 题
A medical gas distribution system has a working pressure of 50 psi. The installation acceptance test is performed at 1.5 times the working pressure. What is the required test pressure?
a.50 psi
b.75 psi
c.65 psi
d.100 psi
解析
Test pressure = 1.5 x working pressure = 1.5 x 50 = 75 psi. Medical gas piping is proven at 1.5 times its operating pressure to confirm joints and cross connections hold under a margin above service conditions. The standing-pressure and cross-connection tests are performed at this elevated pressure before the system is placed in service.
法律依据: NFPA 99免费刷完整 110 道题库 — 无需注册。
同考点相关题目
- A key difference between the Uniform Plumbing Code and the International Plumbing Code affects where the building drain becomes the building sewer. Which statement correctly pairs the codes?
- An indirect waste pipe has an effective outlet opening of 3/4 in. The required air gap above the receptor flood-level rim is two times the effective opening. What is the minimum air gap?
- A sewage ejector serving fixtures below the sewer must discharge upward and then into the gravity building drain. What fitting protects the pump from gravity backflow when it is off?
- A thermostatic mixing valve blends 140 F stored water with 60 F cold water to deliver 110 F tempered water at a public lavatory. Using a mass balance, what fraction of the delivered flow must be the 140 F hot water?
- A public toilet room fixture count is based on occupant load. If a code table requires one water closet per 40 occupants and the occupant load is 210, how many water closets are the minimum required?
- An oil-water separator serves three garage floor drains each rated at 20 gpm. The code allows sizing at 75 percent of the total connected flow for diversity. What design flow sizes the separator?