Design & Sizing第 6 / 110 题
A copper water line has 90 ft of straight pipe. Fittings add an equivalent length of 3 ft each for four elbows and 8 ft for one gate valve. What is the developed (equivalent) length used for friction-loss calculations?
a.98 ft
b.110 ft
c.122 ft
d.134 ft
解析
Developed length = straight pipe + fitting equivalents = 90 + (4 x 3) + 8 = 90 + 12 + 8 = 110 ft. Friction loss is calculated on this equivalent length, not on the measured pipe alone, because fittings behave like extra pipe. Ignoring fittings understates the loss and can undersize the pipe.
法律依据: UPC §610.0免费刷完整 110 道题库 — 无需注册。
同考点相关题目
- Cold-water piping is commonly limited to a maximum velocity of about 8 ft/s. Using v = 0.408 x Q / d^2, what is the approximate maximum flow a pipe with a 1.025 in inside diameter (nominal 1 in type L copper) can carry without exceeding 8 ft/s?
- A fixture is located 46 ft above the water meter. Using 0.433 psi per foot of elevation, how much static pressure is lost to elevation between the meter and that fixture?
- A system has 62 psi at the meter. It must overcome 22 psi of elevation, 14 psi of friction loss in the piping, and deliver a fixture that requires 8 psi minimum flow pressure. What residual pressure remains at the fixture?
- Available pressure for friction is 30 psi and the total developed length of the water line is 150 ft. What is the maximum allowable uniform friction loss per 100 ft of pipe (the value used to enter a sizing chart)?
- A horizontal drainage branch carries the following drainage fixture units (DFU): 4 water closets at 4 DFU, 4 lavatories at 1 DFU, and 2 kitchen sinks at 2 DFU. What is the total DFU load carried by the branch?
- A horizontal fixture branch carries 30 DFU. The sizing table lists these branch capacities: 2 in = 6 DFU, 3 in = 20 DFU, 4 in = 160 DFU. Two of the fixtures are water closets. What is the minimum pipe size for the branch?