Gas & Fuel第 74 / 110 题
A leak test on an in-service gas line uses a soap-bubble or electronic method rather than a pressure drop. When is the bubble/electronic leak check the appropriate method?
a.On new rough piping before drywall
b.On existing pressurized piping and appliance connections that cannot be depressurized for a formal test
c.Only on propane tanks
d.Never on natural gas
解析
A leak-detection solution or electronic sniffer is used to check joints and connections on piping and appliances that are already in service and under normal operating pressure, where a formal pressure-drop test is impractical. Bubbles at a joint reveal an escaping leak for immediate repair. A never open flame is used to check for gas leaks.
法律依据: IFGC §406.4免费刷完整 110 道题库 — 无需注册。
同考点相关题目
- Each gas appliance must have an accessible manual shutoff. Where must the appliance shutoff valve be located?
- Using the known-air-infiltration method, an appliance space of 10,000 ft^3 is credited with 0.35 air changes per hour of natural infiltration. How many cubic feet of infiltration air per hour does the space provide?
- A gas appliance vent connector runs 12 ft horizontally to the chimney. Code requires a minimum upward rise of 1/4 in per foot toward the chimney. What total vertical rise must the connector have?
- A two-appliance system: appliance A needs 60 cfh and appliance B needs 40 cfh. Using the longest-length method, the section of pipe between the meter and the first tee carries what demand?
- An elevated industrial gas line operates at 5 psi and is regulated down for appliances rated in inches of water column. Using 1 psi = 27.7 in water column, what is 5 psi expressed in inches of water column?
- A natural-gas dryer needs 35,000 BTU/hr and a range needs 65,000 BTU/hr on a shared branch. Using 1,000 BTU/ft^3, what is the combined cfh the common branch must carry?