Water Supply & Distribution第 51 / 120 题
Static pressure at the main is 72 psi. Meter loss at design flow is 9 psi, the highest fixture is 26 ft above the meter, and 15 psi residual is required at that fixture. How much pressure is available to overcome friction loss in the piping?
a.About 41.2 psi
b.About 36.7 psi
c.About 48.0 psi
d.About 25.5 psi
解析
Elevation loss is 26 x 0.433 = 11.26 psi, so 72 - 9 - 11.26 - 15 = 36.7 psi available for friction. The 48.0 psi answer forgets the required residual pressure, and 41.2 psi forgets part of the elevation loss. The 25.5 psi answer subtracts the residual twice or uses a 20 psi flushometer residual that this problem did not specify.
法律依据: UPC §610.0免费刷完整 120 道题库 — 无需注册。
同考点相关题目
- Which copper tube designation has the heaviest wall thickness and is the type commonly required for an underground water service?
- What is the maximum lead content permitted in solder and flux used on a potable water piping system?
- What is the maximum weighted average lead content permitted on the wetted surfaces of pipe, fittings, and fixtures used to convey water for human consumption?
- A flushometer water closet on the top floor requires 20 psi residual. Static pressure is 65 psi, combined meter and backflow preventer loss is 10 psi, and the flush valve is 34 ft above the meter. How much pressure remains for friction loss in the piping and fittings?
- A sizing problem leaves 24 psi available for friction loss. The measured developed length to the most remote fixture is 160 ft, and fittings are estimated to add 50 percent to that length. What is the allowable friction loss per 100 ft of pipe?
- A dwelling unit contains one flush tank water closet (2.5 WSFU), two lavatories (1.0 WSFU each), one bathtub with shower (4.0 WSFU), one kitchen sink (1.5 WSFU), one dishwasher (1.5 WSFU), and one clothes washer (4.0 WSFU). What is the total water supply fixture unit load?