Transmission & Drivetrain (A2/A3)第 21 / 120 题
A clicking noise from the front of a FWD vehicle that increases when turning sharply is most likely caused by:
a.A worn wheel bearing
b.A worn outer CV joint
c.A leaking transmission seal
d.An unbalanced tire
解析
A worn outer CV joint clicks under the load of a sharp turn, and the noise usually worsens with steering angle. A torn boot that allowed grease loss is a frequent cause. Wheel bearing noise, by contrast, is typically a steady drone that changes with vehicle speed.
免费刷完整 120 道题库 — 无需注册。
同考点相关题目
- Technician A says burnt-smelling, dark automatic transmission fluid can indicate overheating and clutch damage. Technician B says fluid color and smell never matter. Who is correct?
- A manual transmission clutch that slips under load, especially in higher gears, most commonly indicates:
- Constant-velocity (CV) joints are used on front-wheel-drive axles primarily because they:
- The differential in a rear axle allows:
- Technician A says a worn driveshaft U-joint can cause a clunk on acceleration. Technician B says it can cause a vibration that increases with vehicle speed. Who is correct?
- A vehicle has a final drive ratio of 3.73:1. This means the: