Transmission & Drivetrain (A2/A3)第 22 / 120 题
The differential in a rear axle allows:
a.The driveshaft to change length
b.The transmission to shift gears
c.The drive wheels to rotate at different speeds during turns
d.The engine to idle smoothly
解析
The differential splits torque to the drive wheels while allowing them to turn at different speeds when cornering, since the outer wheel travels farther. A limited-slip design adds resistance to reduce wheel spin. Whining or howling noises often indicate worn or improperly set-up gears.
免费刷完整 120 道题库 — 无需注册。
同考点相关题目
- A manual transmission clutch that slips under load, especially in higher gears, most commonly indicates:
- Constant-velocity (CV) joints are used on front-wheel-drive axles primarily because they:
- A clicking noise from the front of a FWD vehicle that increases when turning sharply is most likely caused by:
- Technician A says a worn driveshaft U-joint can cause a clunk on acceleration. Technician B says it can cause a vibration that increases with vehicle speed. Who is correct?
- A vehicle has a final drive ratio of 3.73:1. This means the:
- Technician A says most dipstick-equipped automatics are checked with the engine running at operating temperature. Technician B says fluid level is unaffected by temperature. Who is correct?