Drainage, Waste & Vent第 12 / 120 题
Which fitting is acceptable for changing direction from horizontal to vertical in a drainage line?
a.A sanitary tee
b.A double sanitary tee serving back-to-back water closets on a 3 in stack
c.A short quarter bend on the horizontal branch alone
d.A sanitary tee installed on its back so flow enters horizontally
解析
A sanitary tee is designed for horizontal-to-vertical direction change and is the standard approved fitting for that transition. A double sanitary tee is restricted where back-to-back water closets would discharge into each other on an undersized stack, a short quarter bend is not permitted for horizontal-to-horizontal or horizontal-to-vertical drainage flow, and a sanitary tee laid on its back obstructs flow and is prohibited.
免费刷完整 120 道题库 — 无需注册。
同考点相关题目
- A 3 in horizontal drain is run 72 ft at 1/8 in per ft. The invert at the upstream end is at elevation 100.00 ft. What is the invert elevation at the downstream end?
- A vent terminal passes through a roof that is used only for weather protection in an area with no snow-depth requirement. What is the minimum height the vent must extend above the roof surface?
- A vent terminal must be located away from an openable window. Which arrangement satisfies the code?
- Which fitting is required to change direction from horizontal to horizontal in a drainage line?
- A 4 in horizontal building drain runs 340 ft under a warehouse slab. Not counting the cleanout at the upstream end of the run, what is the minimum number of additional cleanouts required for spacing alone?
- A cleanout is installed on a 2 in horizontal waste line in a finished room. What is the minimum clearance required in front of the cleanout?