Systems & Code第 40 / 110 题
A reduced-pressure principle (RP) backflow assembly is installed on a service subject to a health hazard. How must it be installed with respect to the ground and drainage?
a.Below grade in a valve box
b.Flush to a wall with the relief plugged
c.Any orientation as long as it is accessible
d.Above grade with the relief port able to discharge to atmosphere
解析
An RP assembly must be installed above grade with an air gap below its relief port so the relief can discharge freely and be observed; it may not be submerged in a pit that could flood the relief. RP assemblies protect against both backsiphonage and backpressure of high-hazard (health) cross connections. Submerging or plugging the relief defeats the protection.
法律依据: UPC §603.0免费刷完整 110 道题库 — 无需注册。
同考点相关题目
- A hot-water recirculation loop loses 4,000 BTU/hr to the piping. The pump must circulate enough water so it cools only 20 F while replacing that loss. Using Q (gpm) = BTU/hr / (500 x delta-T), what recirculation flow is required?
- A temperature-and-pressure (T and P) relief valve on a water heater is rated to open at 210 F and 150 psi. What is the required disposition of its discharge pipe?
- A closed water-supply system (with a backflow preventer or check valve at the meter) has a water heater but no expansion control. As the water heats and expands, what device is required to prevent pressure buildup?
- A lawn irrigation system with chemical injection is connected to a potable supply. This is classified as a high health hazard under backpressure and backsiphonage conditions. Which backflow assembly is required?
- An air gap is used to protect a potable outlet discharging over a flood-level rim. What is the minimum air gap for an effective opening of 1 in diameter, using the rule of two times the effective opening?
- In a medical gas piping system, oxygen and other medical gases must use tubing that is cleaned and labeled for the service. What copper tubing is required for medical gas distribution?