Core TradesQuestion 197 of 700
What is the typical MINIMUM clearance to combustible materials for a single-wall metal vent connector on a fuel-burning appliance?
a.1 inch
b.3 inches
c.6 inches
d.12 inches
Explanation
A single-wall metal vent connector typically requires at least 6 inches of clearance to combustibles because its outer surface runs hot. 1 and 3 inches are too close for single-wall pipe, and 12 inches is greater than the standard required clearance.
Law Reference: 2025 CA Mechanical Code, Chapter 8 (Vents and Connectors)Practice all 700 questions free — no signup required.
Related questions on this topic
- Using the all-outdoor two-permanent-opening method at a rate of 1 square inch per 4,000 Btu/hr per opening, what is the MINIMUM net free area of EACH opening for a 100,000 Btu/hr furnace?
- Under the California Energy Code, sealing forced-air duct systems is required PRIMARILY to:
- What is a common MINIMUM intermittent exhaust airflow required for a residential bathroom fan?
- A ducted residential kitchen range hood that exhausts to the outdoors is commonly required to move a MINIMUM intermittent airflow of about:
- A roof has 2,400 square feet of surface area to be covered with three-tab asphalt shingles. At 3 bundles per square (100 sq ft), how many bundles are needed before adding any waste allowance?
- Where a sloped shingle roof meets a vertical sidewall, the flashing that is woven in shingle-by-shingle to direct water onto the roof surface is called:
Last reviewed: · editorial process
PrepPass Editorial Team · Verified against California CSLB General Building (B) Trade Examination · How we review