Finish TradesQuestion 249 of 700
A wall that will receive a high-gloss enamel or be raked by strong sidelighting typically requires the highest drywall finish. Under the industry levels of gypsum finish, that is:
a.Level 1
b.Level 5
c.Level 2
d.Level 0
Explanation
Level 5 finish adds a skim coat over the entire surface for the smoothest result, needed under gloss paints and critical (raking) lighting. Levels 0 to 2 are minimal finishes for concealed or utility surfaces and would show every imperfection under gloss or sidelight.
Practice all 700 questions free — no signup required.
Related questions on this topic
- During cabinet installation, a narrow gap remains between the last cabinet and a side wall or an appliance. The clean, professional way to close that gap is to use:
- Fire-rated gypsum board used to achieve a one-hour wall assembly is commonly Type X. Its typical nominal thickness is:
- On long, continuous drywall walls and ceilings, control (expansion) joints are added to relieve stress. A common guideline places control joints in walls at a MAXIMUM spacing of about:
- To reduce ceiling sag when a water-based spray texture will be applied, code and industry guidance generally require which gypsum board for ceilings framed 16 inches on center?
- Which combination of assembly changes will BEST raise the Sound Transmission Class (STC) of an interior partition?
- On gypsum board joints, paper tape and mesh (self-adhesive fiberglass) tape behave differently. A key reason many finishers use PAPER tape at inside corners is that:
Last reviewed: · editorial process
PrepPass Editorial Team · Verified against California CSLB General Building (B) Trade Examination · How we review