Planning & EstimatingQuestion 371 of 521
When four or more fastened-in-place appliances (other than the range, dryer, space heating, and air conditioning) are on the same feeder in a dwelling, what demand factor may be applied to their total nameplate load?
a.100%
b.50%
c.80%
d.75%
Explanation
A demand factor of 75% is permitted where four or more such fastened-in-place appliances are served. With three or fewer, no reduction applies, so 100% would be used only in that case.
Law Reference: 2023 NEC §220.53Practice all 521 questions free — no signup required.
Related questions on this topic
- During the permit process, when is the rough (rough-in) electrical inspection normally performed?
- The optional calculation method of 220.82 may be used for a dwelling served by a single 120/240 V feeder or service rated at least how many amperes?
- A 1,500 ft² dwelling's standard-method calculation yields 13,100 VA on 240 V (about 55 A). What is the minimum service disconnect rating required?
- What is the minimum number of 20 A small-appliance branch circuits required to serve the kitchen, dining, and similar areas of a dwelling?
- What unit load per square foot is used for general lighting in a dwelling unit?
- Which loads may be added to the general lighting load and then subjected together to the 220.42 general-lighting demand factors?
Last reviewed: · editorial process
PrepPass Editorial Team · Verified against California CSLB C-10 Electrical Trade Examination · How we review