Drainage, Waste & Vent第 20 / 120 题
A kitchen sink is located in an island counter where no wall is available for a conventional vent. Which venting method is designed for this condition?
a.Circuit vent
b.Yoke vent
c.Vent stack
d.Island or loop vent
解析
An island or loop vent rises as high as possible under the counter, returns downward, and then connects to a vent line, which is the method developed for fixtures with no adjacent wall. A circuit vent serves a battery of floor-set fixtures, a yoke vent relieves pressure between a drainage stack and its vent stack, and a vent stack is the vertical vent serving a whole drainage stack rather than a single island fixture.
免费刷完整 120 道题库 — 无需注册。
同考点相关题目
- Under the UPC, where does the building drain end and the building sewer begin?
- A single 3 in vent stack is 46 ft in developed length and serves a drainage stack. If the code limits a given vent size to a maximum developed length, exceeding that length requires which action?
- Two lavatories are installed back to back on opposite sides of a wall and discharge into the same double fitting at the same level. What vent arrangement is being used?
- An air admittance valve is used to vent an island sink. Which statement describes a correct installation?
- What is the maximum vertical distance permitted between a fixture outlet and the trap weir serving that fixture?
- A commercial kitchen has a two-compartment sink whose drain must not connect directly to the sanitary drainage system. How must it discharge?