Testing & TroubleshootingQuestion 513 of 521
Before connecting a three-phase motor to a new feeder, why would you use a phase-rotation (phase-sequence) meter on the supply?
a.To determine the phase sequence (A-B-C vs A-C-B) so the motor will rotate in the intended direction
b.To measure insulation resistance of the feeder
c.To read the exact current the motor will draw
d.To verify the neutral is bonded
Explanation
A phase-rotation meter identifies the sequence of the three phases so you can connect the motor for correct rotation before energizing, avoiding damage from running backward (e.g., pumps, compressors). It does not measure insulation (b), load current (c), or neutral bonding (d).
Practice all 521 questions free — no signup required.
Related questions on this topic
- Three parallel loads on a 120 V circuit draw 4 A, 6 A, and 5 A respectively. What total current should a clamp meter read on the feeder conductor?
- A non-contact voltage tester (NCVT) does not light up near a conductor you must work on. Before treating the conductor as dead, what is the correct action?
- A single-phase load operates at 240 V and draws 20 A at unity power factor. What is its power in kilowatts?
- Using the rule of thumb of 1 megohm minimum per 1,000 V of rating, what is the minimum acceptable insulation resistance for a 4,160 V motor?
- Why does over-torquing a lug or terminal screw create a hazard, even though the connection feels 'extra tight'?
- A homeowner reports that throughout the house, some lights dim while others brighten, and the effect shifts as loads switch on and off. Which service-level fault best explains this?
Last reviewed: · editorial process
PrepPass Editorial Team · Verified against California CSLB C-10 Electrical Trade Examination · How we review