Service & TroubleshootingQuestion 92 of 110
When a heat pump is stuck in cooling on a heat call, which component is a prime suspect?
a.The condensate trap
b.The air filter
c.The reversing valve or its solenoid coil
d.The supply registers
Explanation
If a heat pump blows cold air on a heating call, the reversing valve may be stuck or its solenoid coil or control signal may have failed, leaving the system in cooling mode. The technician checks the coil, the control voltage, and valve operation. A stuck valve often requires replacement.
Practice all 110 questions free — no signup required.
Related questions on this topic
- When measuring the actual airflow of an installed system, which measurement helps diagnose a restrictive duct system?
- A capacitor that reads well below its rated microfarad value should be treated how?
- Recommended routine maintenance to preserve airflow and efficiency includes what?
- A technician measuring compressor amp draw far above the rated load amps (RLA) should suspect what?
- The most likely cause of no cooling when the thermostat calls but the outdoor unit is completely silent is what?
- An ECM (electronically commutated motor) blower offers what advantage over a standard PSC motor?
Last reviewed: · editorial process
PrepPass Editorial Team · Verified against California CSLB C-20 Warm-Air HVAC Trade Exam · How we review