SafetyQuestion 650 of 700
Wood platform planks on a scaffold are supported at each end. Where planks are overlapped rather than butted, the overlap must occur over a support and extend at least how far past the centerline of the support?
a.At least 2 inches
b.At least 6 inches
c.At least 12 inches
d.At least 24 inches
Explanation
Correct: overlapped planks must overlap only over a support and extend at least 12 inches beyond the support's centerline (unless cleated or otherwise restrained). A 2- or 6-inch overlap risks the plank sliding off. 24 inches is more than required and, at the far end, a plank should not extend excessively past a support (generally no more than about 12-18 inches unless designed) to avoid a tipping/see-saw hazard.
Practice all 700 questions free — no signup required.
Related questions on this topic
- A temporary cover is placed over a floor opening in a walkway. Which set of requirements BEST describes a compliant hole cover?
- Safety nets are chosen as fall protection under a leading edge. Which pair of requirements is correct for safety nets?
- A supported scaffold and its components are being specified. Each part of the scaffold and its supports must be capable of holding at least how many times the maximum intended load without failure?
- Workers need to reach a scaffold platform 9 feet above the base. Which access method is required under Cal/OSHA?
- Who must inspect a scaffold for visible defects, and how often, before it is used?
- CALCULATION: A free-standing supported scaffold has a minimum base width of 5 feet. Using the common 4:1 height-to-base ratio, at what height must the scaffold first be tied, guyed, or braced to the structure to prevent tipping?
Last reviewed: · editorial process
PrepPass Editorial Team · Verified against California CSLB General Building (B) Trade Examination · How we review