Water Supply & DistributionQuestion 57 of 360
After installing a new RP assembly on a high-hazard connection, what ongoing requirement typically applies?
a.Periodic testing by a certified tester (commonly annually) to verify it still functions
b.No further action ever
c.It self-certifies and never needs testing
d.It only needs testing if it leaks visibly
Explanation
Testable backflow assemblies such as RP devices require periodic testing by a certified tester, commonly on an annual basis, to verify continued protection. They do not self-certify, are not exempt from testing, and testing is not limited to only when visible leaks occur.
Law Reference: 2022 California Plumbing Code (CPC) §603.0Practice all 360 questions free — no signup required.
Related questions on this topic
- To allow individual maintenance, where does good practice and code generally require shutoff (angle stop) valves in a dwelling?
- A two-story home has the main run in the crawlspace and risers to the second floor. To minimize pressure loss to upstairs fixtures during simultaneous use, which strategy is best?
- A dental office has vacuum and treatment equipment connected to the potable supply, presenting a health hazard with possible backpressure. Which premise-isolation assembly is appropriate?
- Threaded steel (galvanized) water pipe is run horizontally. What is the typical maximum horizontal support spacing?
- A single check valve is proposed as backflow protection for a high-hazard chemical connection. Why is this not acceptable?
- A homeowner reports faucets that hammer and leak, and you measure 105 psi static. Besides installing arrestors at quick-closing valves, what is the primary corrective action?
Last reviewed: · editorial process
PrepPass Editorial Team · Verified against California CSLB C-36 Plumbing Trade Examination · How we review