Engine Repair (A1)Câu 9 / 120
A radiator pressure cap raises the system's boiling point primarily because:
a.It adds antifreeze to the coolant
b.Increased pressure raises the coolant's boiling temperature
c.It lowers the coolant level
d.It speeds up the water pump
Giải thích
Sealing the system under pressure raises the boiling point of the coolant, allowing higher operating temperatures without boil-over. A weak or faulty cap lowers the effective boiling point and can cause coolant loss. Caps should be pressure-tested when overheating is suspected.
Luyện miễn phí toàn bộ 120 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A mechanic measures cylinder taper by comparing bore diameter at the top of ring travel to the bottom. This measurement is taken with a:
- Technician A says low oil pressure only at idle on a high-mileage engine can be caused by worn bearing clearances. Technician B says a worn oil pump or diluted oil can also lower pressure. Who is correct?
- Which cooling-system component regulates coolant flow based on engine temperature?
- Blue smoke from the exhaust under acceleration most often indicates:
- Technician A says timing-chain stretch can retard valve timing and set a camshaft/crankshaft correlation code. Technician B says a stretched timing chain has no effect on engine performance. Who is correct?
- Head bolts that use a torque-to-yield (TTY) design should be:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với ASE Automobile Certification Series (A1–A8) · Quy trình kiểm tra