Vehicle InspectionCâu 17 / 120
At what pressure should the air compressor governor normally cut out and stop pumping air?
a.Between 60 and 80 psi
b.Between 85 and 100 psi
c.Between 120 and 140 psi
d.Between 150 and 170 psi
Giải thích
The governor typically cuts out somewhere between 120 and 140 psi and cuts back in around 85 to 100 psi. Cutting out at 60 to 80 psi would leave too little reserve, and 150 to 170 psi would over-pressurize the system.
Luyện miễn phí toàn bộ 120 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- During the applied-pressure portion of your air-brake test, what does the low-pressure warning coming on at 55 psi tell you?
- During the static leak test you find air pressure dropping steadily and you can hear a hiss near the trailer air lines. What should you do?
- You start the engine with the air tanks nearly empty and watch the gauge. On a dual air system, roughly how quickly should pressure build from 85 to 100 psi at operating rpm?
- You are performing the tug test after coupling. What are you actually checking?
- Which wheel and rim condition requires the vehicle to be taken out of service?
- You notice oil or grease on the outside of a brake drum during your walkaround. Why does this matter?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với Commercial Driver's License (CDL) General Knowledge Test · Quy trình kiểm tra