Vehicle InspectionCâu 23 / 120
You are checking slack adjusters on an S-cam brake by pulling the pushrod by hand with the brakes released. What indicates the brakes are out of adjustment?
a.The pushrod moves more than about one inch where it leaves the chamber
b.The pushrod does not move at all
c.The slack adjuster is warm to the touch
d.The brake chamber is mounted upside down relative to the axle
Giải thích
More than roughly one inch of hand movement at the point the rod leaves the chamber signals brakes that need adjusting and will not develop full force. No movement is normal for a properly adjusted brake, warmth is expected after driving, and chamber orientation varies by design.
Luyện miễn phí toàn bộ 120 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- You notice oil or grease on the outside of a brake drum during your walkaround. Why does this matter?
- Which item is checked as part of the in-cab portion of the pre-trip inspection?
- The previous driver's inspection report lists a defect that the shop has certified as repaired. What must you do before driving?
- After a trip you find a small crack in the windshield directly in the driver's line of sight and a wiper blade that is torn. What is the correct assessment?
- Which statement best describes the driver's legal responsibility before operating a commercial vehicle?
- You are inspecting the air lines between tractor and trailer. Which condition is acceptable?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với Commercial Driver's License (CDL) General Knowledge Test · Quy trình kiểm tra