Finish TradesCâu 228 / 700
Interior tile floors need periodic movement (expansion) joints. Industry guidance commonly recommends interior movement joints roughly every ____, and MORE frequently for floors exposed to sunlight or moisture.
a.50 to 60 feet
b.20 to 25 feet
c.5 to 8 feet
d.Only at the room's exact center
Giải thích
Interior tile floors typically get movement joints about every 20 to 25 feet (and at changes of plane and abutting restraints), with tighter spacing (roughly 8 to 12 feet) where exposed to sun or moisture. Fifty-plus feet is too far apart, 5 to 8 feet is unnecessarily tight for typical interiors, and a single center joint ignores perimeter restraint.
Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A tile setter spreads thinset mortar but leaves it too long before placing tile, and a skin forms on the ridges. What is the MAIN risk of setting tile into skinned-over thinset?
- An uncoupling (crack-isolation) membrane is installed between a concrete slab and ceramic tile. Its PRIMARY purpose is to:
- For a wet area like a shower, industry standards limit allowable framing/subfloor deflection so tile does not crack. A common maximum for ceramic tile is about L/360, but NATURAL STONE typically requires a stiffer floor of about:
- A shower receptor will use a liquid-applied waterproofing membrane over the tile backer. The MOST important installer control for a reliable waterproof layer is to:
- A tile order calls for covering a floor of 240 square feet. The chosen tile comes in boxes that each cover 11 square feet. Adding about 10% for cuts and waste, how many full boxes should be ordered?
- When setting translucent or moisture-sensitive natural stone (such as certain marbles), a WHITE, non-staining setting mortar is preferred over a gray latex thinset MAINLY because:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra