Framing & StructuralCâu 330 / 700
On a wood I-joist, where may holes generally be cut, and which part must never be cut or notched?
a.Anywhere in the flange; the web is off-limits
b.Only in the flange near supports
c.In the web per the manufacturer's hole chart; the flanges must never be cut or notched
d.Anywhere, because I-joists are solid
Giải thích
An I-joist carries bending through its top and bottom flanges, so the flanges must never be cut or notched; holes are allowed only in the web and only where the manufacturer's hole chart permits. Cutting flanges destroys the joist's capacity, and I-joists are not solid members.
Trích dẫn luật: 2025 CA Residential Code §R502.11Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- What is the purpose of permanent lateral bracing on the web members of long-span roof trusses?
- When a bird's-mouth seat cut is made where a rafter bears on the top plate, what limits how deep that notch may be cut?
- CALCULATION: A hip rafter runs diagonally across the plan corner of a roof. Compared with a common rafter having the same rise, the hip rafter is:
- At the bearing ends of many wood I-joists, what component is often required to prevent web crushing or rotation?
- For laminated veneer lumber (LVL) and glued-laminated (glulam) beams, where must any holes or notches be located and sized?
- A glued-laminated (glulam) beam is stamped 'TOP' along one edge. Why must it be installed with that face up?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra