Finish TradesCâu 472 / 700
When gypsum board is attached to wall framing with screws, what is the typical MAXIMUM fastener spacing along each stud?
a.8 inches on center
b.16 inches on center
c.24 inches on center
d.4 inches on center
Giải thích
For screw attachment of gypsum board to walls, fasteners are typically spaced no more than 16 inches on center along each framing member. 8 and 4 inches are tighter than needed, and 24 inches is too far apart to hold the board flat and secure.
Trích dẫn luật: 2025 CA Residential Code §R702.3.5Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- When selecting a window, the Solar Heat Gain Coefficient (SHGC) primarily describes what performance property?
- Every dwelling unit must have at least one egress door that provides a clear width of not less than what, and a clear height of not less than 78 inches?
- Before installation is approved, site-built and manufactured fenestration products must generally carry which label so their energy ratings can be verified?
- In a suspended (grid) acoustical ceiling, the hanger wires that support the main runners are generally spaced at a MAXIMUM of what along each runner?
- In finish carpentry, why are inside corners of base or crown molding often coped rather than mitered?
- Porous natural stone such as travertine or honed limestone is typically sealed before use MAINLY to accomplish what?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra