Systems & CodeCâu 32 / 110
A wet-vented bathroom group discharges 5 DFU to a wet vent section. Wet vent capacity limits are 1-1/2 in = 1 DFU, 2 in = 4 DFU, and 3 in = 6 DFU. What is the minimum wet vent size?
a.1-1/2 in
b.2 in
c.4 in
d.3 in
Giải thích
The 5 DFU load exceeds the 4 DFU capacity of a 2 in wet vent, so the next size, 3 in (6 DFU), is required. A wet vent uses an oversized drain to also serve as a vent, but only up to the fixture-unit cap for its size. Exceeding the cap forces a larger wet vent or separate venting.
Trích dẫn luật: UPC §908.0Luyện miễn phí toàn bộ 110 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A circuit vent serves a battery of floor-mounted fixtures on a horizontal branch. What is the maximum number of fixtures a single circuit vent may serve, and where is the vent taken off?
- A commercial kitchen installs a grease interceptor rated for a flow of 35 gpm. Using the common rule that grease capacity in pounds is about twice the gpm rating, what nominal grease retention does this unit provide, and what is its purpose?
- A building drain serving fixtures below the elevation of the public sewer manhole must be protected against sewer backflow. Which device is required on that low-level drainage?
- A basement floor drain sits 3 ft below the elevation of the upstream sewer manhole cover. During a main surcharge, how much backpressure head could push up through that drain if unprotected, using 0.433 psi per foot?
- A hot-water recirculation loop loses 4,000 BTU/hr to the piping. The pump must circulate enough water so it cools only 20 F while replacing that loss. Using Q (gpm) = BTU/hr / (500 x delta-T), what recirculation flow is required?
- A temperature-and-pressure (T and P) relief valve on a water heater is rated to open at 210 F and 150 psi. What is the required disposition of its discharge pipe?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với Master Plumber Licensing Exam (UPC/IPC-based) · Quy trình kiểm tra