Design & SizingCâu 5 / 110
A system has 62 psi at the meter. It must overcome 22 psi of elevation, 14 psi of friction loss in the piping, and deliver a fixture that requires 8 psi minimum flow pressure. What residual pressure remains at the fixture?
a.18 psi
b.8 psi
c.14 psi
d.16 psi
Giải thích
Residual = 62 - 22 (elevation) - 14 (friction) = 26 psi available at the fixture, which exceeds the 8 psi required, leaving 26 - 8 = 18 psi of margin. The design works because the delivered 26 psi is greater than the 8 psi minimum. The pressure budget must always balance supply against elevation, friction, and fixture demand.
Trích dẫn luật: UPC §610.0Luyện miễn phí toàn bộ 110 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Using the 0.408 velocity relationship v = 0.408 x Q / d^2 (v in ft/s, Q in gpm, d in inches inside diameter), what is the velocity of 18 gpm flowing in a pipe with a 1.00 in inside diameter?
- Cold-water piping is commonly limited to a maximum velocity of about 8 ft/s. Using v = 0.408 x Q / d^2, what is the approximate maximum flow a pipe with a 1.025 in inside diameter (nominal 1 in type L copper) can carry without exceeding 8 ft/s?
- A fixture is located 46 ft above the water meter. Using 0.433 psi per foot of elevation, how much static pressure is lost to elevation between the meter and that fixture?
- A copper water line has 90 ft of straight pipe. Fittings add an equivalent length of 3 ft each for four elbows and 8 ft for one gate valve. What is the developed (equivalent) length used for friction-loss calculations?
- Available pressure for friction is 30 psi and the total developed length of the water line is 150 ft. What is the maximum allowable uniform friction loss per 100 ft of pipe (the value used to enter a sizing chart)?
- A horizontal drainage branch carries the following drainage fixture units (DFU): 4 water closets at 4 DFU, 4 lavatories at 1 DFU, and 2 kitchen sinks at 2 DFU. What is the total DFU load carried by the branch?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với Master Plumber Licensing Exam (UPC/IPC-based) · Quy trình kiểm tra