Gas & FuelCâu 63 / 110
A high-efficiency condensing furnace exhausts cool, wet flue gas under positive pressure. What venting category and material are appropriate?
a.Category I, type B vent
b.Category II, single-wall steel
c.Category IV, listed PVC/CPVC sealed vent
d.Category III, masonry chimney
Giải thích
A condensing furnace is Category IV, operating at positive vent pressure with condensing (wet, acidic) flue gas, and it requires a listed, sealed PVC or CPVC vent that resists corrosion and holds pressure. A type B vent or masonry chimney would corrode and leak flue products. The condensate must also be drained and often neutralized.
Trích dẫn luật: IFGC §503.0Luyện miễn phí toàn bộ 110 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- An appliance room contains a 120,000 BTU/hr furnace and a 40,000 BTU/hr water heater drawing combustion air from inside. Using the rule of 50 cubic feet of room volume per 1,000 BTU/hr for indoor air, what minimum room volume is required?
- Combustion air is taken from outdoors using two openings, one high and one low. The rule is 1 square inch of free area per 4,000 BTU/hr for each opening when using direct outdoor openings. For a 200,000 BTU/hr appliance load, what is the minimum free area of each opening?
- Appliance venting is classified by category. A Category I appliance is best described as which of the following?
- Corrugated stainless steel tubing (CSST) must be electrically bonded to reduce the risk of arcing from a lightning-induced surge. Where is the bonding clamp attached?
- A newly installed natural-gas piping system is pressure tested before being placed in service. A common test is 3 psi (or 1.5 times working pressure, whichever is greater) held for a set duration. For low-pressure residential piping, what is a typical minimum test pressure and duration?
- During a gas pressure test, appliances and their regulators must be protected. What is the correct way to include or exclude appliances during a 10 psi test?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với Master Plumber Licensing Exam (UPC/IPC-based) · Quy trình kiểm tra