Loading & PerformanceCâu 87 / 100
A fixed-wing sUAS has an empty airframe weight of 38.5 lbs. You install a 9.2 lb battery pack, a 5.4 lb sensor pod, and 1.3 lbs of mounting hardware. May this aircraft be flown under Part 107?
a.Yes; the takeoff weight of 54.4 lbs is under the 55 lb limit
b.No; the takeoff weight of 55.4 lbs is over the 55 lb limit
c.Yes; only the 45.2 lbs without the battery counts toward the limit
d.No; the sensor pod must be removed to stay under the 55 lb limit
Giải thích
Adding every installed item gives 38.5 + 9.2 + 5.4 + 1.3 = 54.4 lbs, which is below the 55 lb ceiling, so the flight is legal with 0.6 lbs to spare. The 55.4 lbs figure is an arithmetic slip, and the battery can never be excluded because it is on board at takeoff. Nothing has to be removed, although the small margin means any added camera or cargo must be re-checked.
Trích dẫn luật: 14 CFR §107.3Luyện miễn phí toàn bộ 100 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Your quadcopter normally flies about 24 minutes on a full battery at 70 °F. You are launching on a 25 °F morning, and the manufacturer warns that cold can reduce usable battery capacity by roughly 25%. About how much flight time should you plan for?
- How does loading a small UAS close to its maximum takeoff weight affect its performance?
- You are launching a fully loaded multirotor from a mountain meadow at 7,500 ft MSL on a hot afternoon. How does the high density altitude affect performance?
- During preflight you notice that one of your lithium-polymer battery packs has a slight bulge in its case. What should you do?
- A remote pilot launches a small UAS loaded above the manufacturer's maximum gross weight, and a sudden gust pushes it off the intended path. What should the pilot expect?
- Before flying a new payload on a windy day, where should a remote pilot find the aircraft's weight limits and performance data?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với FAA Part 107 Remote Pilot Certificate Knowledge Test · Quy trình kiểm tra