DecontaminationCâu 20 / 100
A lumened suction instrument arrives in decontamination. Which cleaning practice is correct?
a.Soak the device for one hour and rely on the soak to clear the lumen
b.Run the device through the ultrasonic cleaner only, since brushes cannot reach the channel
c.Flush the lumen with a high-pressure air gun before any liquid contacts the device
d.Flush the channel with detergent solution and brush it with a brush of the correct diameter and length, then rinse thoroughly
Giải thích
Lumens require mechanical action delivered by a brush that actually contacts the internal wall along the full channel length, followed by thorough flushing and rinsing. A brush that is too small does not touch the walls and one that is too large cannot pass. Soaking alone, ultrasonic alone, or blowing air through a dry contaminated channel will not remove adherent biofilm and soil.
Trích dẫn luật: AAMI ST79Luyện miễn phí toàn bộ 100 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A new sterile processing department is being designed. Which statement describes correct workflow?
- Soiled instruments must be transported from the operating room to the decontamination area on a different floor. What is required?
- A decontamination area is equipped with three sinks. What is the intended use of each?
- Instrument sets are consistently arriving in decontamination with hard, dried blood in box locks and serrations. What is the most likely root cause?
- A technician keeps a covered coffee cup on a shelf above the decontamination sink. How should this be addressed?
- Instruments are coming out of the washer with a chalky white film. Water testing shows high hardness. What is the appropriate corrective action?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với HSPA Certified Registered Central Service Technician (CRCST) Exam · Quy trình kiểm tra