Transmission & Drivetrain (A2/A3)Câu 23 / 120
Technician A says a worn driveshaft U-joint can cause a clunk on acceleration. Technician B says it can cause a vibration that increases with vehicle speed. Who is correct?
a.Technician A only
b.Technician B only
c.Both A and B
d.Neither A nor B
Giải thích
A worn universal joint clunks when torque is applied and vibrates more as speed rises because the joint develops play. Both technicians describe valid symptoms. Rust-colored dust around the caps is an early sign of failure.
Luyện miễn phí toàn bộ 120 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Constant-velocity (CV) joints are used on front-wheel-drive axles primarily because they:
- A clicking noise from the front of a FWD vehicle that increases when turning sharply is most likely caused by:
- The differential in a rear axle allows:
- A vehicle has a final drive ratio of 3.73:1. This means the:
- Technician A says most dipstick-equipped automatics are checked with the engine running at operating temperature. Technician B says fluid level is unaffected by temperature. Who is correct?
- Technician A says a slipping band or clutch pack can cause delayed or harsh shifts. Technician B says low line pressure can cause slipping and overheating. Who is correct?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với ASE Automobile Certification Series (A1–A8) · Quy trình kiểm tra