Transmission & Drivetrain (A2/A3)Câu 20 / 120
Constant-velocity (CV) joints are used on front-wheel-drive axles primarily because they:
a.Are cheaper than U-joints
b.Require no lubrication
c.Eliminate the need for a differential
d.Transmit power smoothly through varying steering angles
Giải thích
CV joints deliver constant rotational speed while the axle operates through the wide angles created by steering and suspension travel. A torn CV boot lets grease escape and dirt enter, leading to a clicking noise during turns. Boot inspection is a routine maintenance check.
Luyện miễn phí toàn bộ 120 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- In an automatic transmission, the torque converter's function is to:
- Technician A says burnt-smelling, dark automatic transmission fluid can indicate overheating and clutch damage. Technician B says fluid color and smell never matter. Who is correct?
- A manual transmission clutch that slips under load, especially in higher gears, most commonly indicates:
- A clicking noise from the front of a FWD vehicle that increases when turning sharply is most likely caused by:
- The differential in a rear axle allows:
- Technician A says a worn driveshaft U-joint can cause a clunk on acceleration. Technician B says it can cause a vibration that increases with vehicle speed. Who is correct?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với ASE Automobile Certification Series (A1–A8) · Quy trình kiểm tra