Brakes (A5)Câu 54 / 120
During a disc brake job, a technician should measure rotor thickness and compare it to the:
a.Tire pressure specification
b.Battery voltage
c.Toe specification
d.Minimum (discard) thickness stamped on the rotor
Giải thích
Rotors must remain above the minimum thickness (often cast or stamped on the rotor) to dissipate heat and resist warping. A rotor below spec must be replaced, not machined. Measuring with a micrometer at several points also reveals thickness variation.
Luyện miễn phí toàn bộ 120 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- The main function of an anti-lock brake system (ABS) is to:
- A wheel-speed sensor signal that is missing on one wheel will most likely cause the ABS to:
- Brake fluid is hygroscopic, which means it:
- Technician A says brake shoes are used in disc brakes. Technician B says brake shoes are used in drum brakes. Who is correct?
- Technician A says a grinding, metal-on-metal noise during braking indicates friction material worn past its limit. Technician B says continued driving in that condition can score the rotor or drum. Who is correct?
- A rear disc parking brake that will not hold is often caused by:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với ASE Automobile Certification Series (A1–A8) · Quy trình kiểm tra