Vehicle InspectionCâu 1 / 120
You arrive for your shift and the tractor was driven by another driver yesterday. Before you move the vehicle, what does the federal rule require you to do first?
a.Drain the air tanks and rebuild pressure from zero
b.Weigh the loaded vehicle at the nearest certified scale
c.Review the last driver vehicle inspection report and be satisfied the vehicle is in safe operating condition
d.Road test the vehicle for at least two miles before loading
Giải thích
A driver must review the previous driver's inspection report and sign it if defects were noted and certified as repaired, then be satisfied the vehicle is safe to operate. Draining tanks completely and rebuilding pressure is not a required daily step, weighing is a cargo issue rather than a pre-trip requirement, and no minimum road-test distance is required before loading.
Trích dẫn luật: 49 CFR §396.13Luyện miễn phí toàn bộ 120 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- What is the minimum legal tread depth in a major groove of a front steering-axle tire on a commercial motor vehicle?
- During your walkaround you measure 3/32 inch of tread on a drive-axle tire and 5/32 inch on a steer tire. What is the correct conclusion?
- At what air pressure must the low-air-pressure warning device on an air-brake vehicle come on?
- You are running the air-brake check with a fully charged system, engine off, and the service brakes released. What is the maximum allowable air pressure loss per minute for a combination vehicle?
- With the engine off and the air system fully charged, you begin fanning off air pressure with the brake pedal. At roughly what pressure should the tractor protection valve and parking brake valve pop out?
- Which sequence correctly describes the seven-step inspection method?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với Commercial Driver's License (CDL) General Knowledge Test · Quy trình kiểm tra