Vehicle InspectionCâu 4 / 120
At what air pressure must the low-air-pressure warning device on an air-brake vehicle come on?
a.At or below 45 psi
b.At or below 60 psi
c.At or below 85 psi
d.At or below 20 psi
Giải thích
The low-pressure warning light and buzzer must activate at or before pressure drops to 60 psi, giving the driver time to stop while service brakes still work. Around 85 psi is a typical governor cut-in point, and 20 to 45 psi is the range in which spring brakes apply automatically, which is far too late for a warning.
Trích dẫn luật: 49 CFR §393.51Luyện miễn phí toàn bộ 120 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- You arrive for your shift and the tractor was driven by another driver yesterday. Before you move the vehicle, what does the federal rule require you to do first?
- What is the minimum legal tread depth in a major groove of a front steering-axle tire on a commercial motor vehicle?
- During your walkaround you measure 3/32 inch of tread on a drive-axle tire and 5/32 inch on a steer tire. What is the correct conclusion?
- You are running the air-brake check with a fully charged system, engine off, and the service brakes released. What is the maximum allowable air pressure loss per minute for a combination vehicle?
- With the engine off and the air system fully charged, you begin fanning off air pressure with the brake pedal. At roughly what pressure should the tractor protection valve and parking brake valve pop out?
- Which sequence correctly describes the seven-step inspection method?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với Commercial Driver's License (CDL) General Knowledge Test · Quy trình kiểm tra