Core TradesCâu 101 / 700
A high-efficiency (condensing) furnace produces acidic condensate. This condensate must be:
a.Drained to an approved location, often with neutralization, and not allowed to damage materials
b.Vented up the flue with the exhaust gases
c.Left to evaporate inside the cabinet
d.Piped into the return air duct
Giải thích
Condensing furnaces generate acidic condensate that must be routed to an approved drain, often neutralized, to avoid corroding materials and clogging. It cannot go up the flue, evaporate in the cabinet, or enter the return air where it would spread moisture and corrosion.
Trích dẫn luật: 2025 CA Mechanical CodeLuyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- During a split-system AC installation, the refrigerant line set is run with several tight kinks and an excessively long distance beyond the manufacturer's limit. The MOST likely result is:
- CALCULATION: A room measures 20 ft by 15 ft with a 10-ft ceiling. A ventilation system supplies 500 cubic feet per minute (CFM). Approximately how many air changes per hour (ACH) does this provide?
- A clothes dryer exhaust duct is run with several sharp bends and a long concealed length, then vented into an attic. Two problems with this install are:
- Supply and return ducts installed in an unconditioned attic are typically required to be insulated and sealed MAINLY to:
- At the intersection of two sloping roof planes, water collects and flows in a channel. The flashing installed in this channel is called:
- Where a sloped shingle roof meets a vertical sidewall, the correct flashing method is:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra