Core TradesCâu 105 / 700
On a low-slope shingle roof, underlayment courses must be lapped so water sheds over each lower course. The MAIN reason for the larger head and side laps on low slopes is:
a.To use more material
b.Slower drainage on low slopes lets water back up, so extra overlap prevents leakage
c.To make the roof heavier
d.To change the roof color
Giải thích
Lower slopes drain slowly and water can back up under the covering, so codes require greater head and side laps (and often doubled underlayment) to keep water out. It is not about using more material for its own sake, adding weight, or color.
Trích dẫn luật: 2025 CA Building Code, Chapter 15 (Roof Assemblies)Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Supply and return ducts installed in an unconditioned attic are typically required to be insulated and sealed MAINLY to:
- At the intersection of two sloping roof planes, water collects and flows in a channel. The flashing installed in this channel is called:
- Where a sloped shingle roof meets a vertical sidewall, the correct flashing method is:
- Asphalt shingles are blowing off in high winds shortly after installation. The MOST likely installation error is:
- Counter flashing at a chimney is installed so that its top edge is embedded in or tucked into a mortar joint of the masonry, MAINLY to:
- CALCULATION: Roofing is estimated in squares (1 square = 100 square feet). A gable roof has two rectangular planes, each 40 feet by 25 feet. How many squares of roofing are needed, before waste?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra