Finish TradesCâu 219 / 700
Bare galvanized steel is to be painted. Which preparation gives the BEST long-term adhesion?
a.Apply an oil-based alkyd primer directly for a chemical bond
b.Leave the shiny zinc surface untouched and topcoat immediately
c.Sand only the visible rust spots and paint over the rest
d.Clean off oils, then use an etching or bonding primer formulated for galvanized metal
Giải thích
Zinc coatings resist paint adhesion and react with oil-based (alkyd) primers to cause saponification and peeling. Cleaning the surface and using an etching or self-etching primer made for galvanizing gives durable adhesion. Direct alkyd primer fails, a slick untouched surface sheds paint, and spot-sanding rust ignores the zinc adhesion problem.
Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Efflorescence (white crystalline deposits) appears on a masonry wall that is scheduled to be painted. What is the BEST way to handle it before coating?
- A painter must achieve a specified DRY film thickness. During application the coating is checked with a wet-film gauge. Why is the WET film reading higher than the target dry film thickness?
- New portland-cement stucco or fresh concrete is highly alkaline. Applying an ordinary oil-based paint too soon can cause which specific failure?
- An old, sound exterior paint film shows heavy chalking (a powdery residue on the surface). Before repainting, the MOST important prep step is to:
- Why do finish carpenters and painters often 'back-prime' exterior wood trim and siding before installation?
- A room measures about 12 ft by 15 ft with 8 ft ceilings. Ignoring openings, the four walls total roughly 432 square feet. If one gallon of paint covers about 350 square feet per coat, how much paint is needed for TWO coats (rounded up to whole gallons)?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra