Finish TradesCâu 221 / 700
Why do finish carpenters and painters often 'back-prime' exterior wood trim and siding before installation?
a.To make the visible face glossier
b.To seal the back and edges so moisture absorption is balanced, reducing cupping and paint failure
c.To eliminate the need for any face primer
d.To add structural strength to the board
Giải thích
Priming the concealed back and edges balances moisture movement into and out of the board, which reduces cupping, warping, and premature failure of the finish coat on the face. It does not change face gloss, replace the face primer, or add strength.
Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- New portland-cement stucco or fresh concrete is highly alkaline. Applying an ordinary oil-based paint too soon can cause which specific failure?
- Bare galvanized steel is to be painted. Which preparation gives the BEST long-term adhesion?
- An old, sound exterior paint film shows heavy chalking (a powdery residue on the surface). Before repainting, the MOST important prep step is to:
- A room measures about 12 ft by 15 ft with 8 ft ceilings. Ignoring openings, the four walls total roughly 432 square feet. If one gallon of paint covers about 350 square feet per coat, how much paint is needed for TWO coats (rounded up to whole gallons)?
- Cedar and redwood siding can bleed brownish stains through ordinary paint. Which primer choice BEST prevents this discoloration?
- Before hanging vinyl wallcovering on new, primed drywall, why is a wallcovering primer/sizing typically applied?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra