Finish TradesCâu 224 / 700
Before hanging vinyl wallcovering on new, primed drywall, why is a wallcovering primer/sizing typically applied?
a.To add a decorative color under the seams
b.To provide a uniform, sealed surface with good adhesion and allow future strippability
c.To eliminate the need to smooth the wall
d.To make the wall permanently waterproof
Giải thích
A wallcovering primer (sizing) seals the surface, evens out porosity for uniform adhesive grab, and lets the paper be stripped later without tearing the drywall face. It is not a decorative layer, does not replace surface prep, and does not make the wall waterproof.
Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Why do finish carpenters and painters often 'back-prime' exterior wood trim and siding before installation?
- A room measures about 12 ft by 15 ft with 8 ft ceilings. Ignoring openings, the four walls total roughly 432 square feet. If one gallon of paint covers about 350 square feet per coat, how much paint is needed for TWO coats (rounded up to whole gallons)?
- Cedar and redwood siding can bleed brownish stains through ordinary paint. Which primer choice BEST prevents this discoloration?
- A tile setter spreads thinset mortar but leaves it too long before placing tile, and a skin forms on the ridges. What is the MAIN risk of setting tile into skinned-over thinset?
- An uncoupling (crack-isolation) membrane is installed between a concrete slab and ceramic tile. Its PRIMARY purpose is to:
- For a wet area like a shower, industry standards limit allowable framing/subfloor deflection so tile does not crack. A common maximum for ceramic tile is about L/360, but NATURAL STONE typically requires a stiffer floor of about:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra