Core TradesCâu 23 / 700
A 240-volt, 30-ampere dedicated circuit is wired with copper conductors. Under typical residential conditions, what is the MINIMUM copper conductor size that matches this 30-ampere circuit?
a.14 AWG
b.12 AWG
c.10 AWG
d.8 AWG
Giải thích
A 30-ampere circuit is normally served by 10 AWG copper, which carries 30 amperes under standard conditions. 14 and 12 AWG are limited to 15 and 20 amperes, while 8 AWG is larger than necessary.
Trích dẫn luật: 2025 CA Electrical Code (CEC) Art. 240 (Overcurrent Protection)Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- In a dwelling, 125-volt receptacles must have GFCI protection when installed within what distance of the outside edge of a kitchen or wet-bar sink?
- Which of the following branch circuits is MOST clearly required to have arc-fault circuit-interrupter (AFCI) protection?
- A device box contains four 12 AWG circuit conductors, two 12 AWG equipment grounding conductors, and one duplex receptacle. Using 2.25 cubic inches per 12 AWG conductor, what MINIMUM box volume is required?
- In new dwelling construction, 15- and 20-ampere, 125-volt receptacles installed in normally accessible locations must generally be:
- For a 2-inch fixture drain, what is a common MAXIMUM developed length of the trap arm (from the trap weir to the vent)?
- The drainage fixture unit (DFU) value assigned to a plumbing fixture PRIMARILY represents:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra