Finish TradesCâu 237 / 700
At the doorway between a tile floor and a lower carpeted room, which transition piece is generally the BEST choice to bridge the height difference?
a.A T-molding, which is for equal-height floors
b.A flush metal divider with no slope
c.A reducer strip that tapers from the higher floor down to the lower one
d.A stair nose molding
Giải thích
A reducer strip is made to transition between two floors of different heights, tapering from the higher surface down to the lower one. A T-molding suits floors of equal height, a flush divider does not handle a height change, and a stair nose is for stair edges.
Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Before installing resilient flooring over a concrete slab, moisture is tested. In the anhydrous calcium chloride test (MVER), results are reported in:
- The in-situ relative humidity (RH) probe test (per ASTM F2170) is another way to check a concrete slab before flooring. Many resilient flooring manufacturers set an acceptable internal RH limit at about:
- Before nailing down solid strip hardwood over a wood subfloor, an installer checks moisture content of BOTH the flooring and the subfloor. Best practice is to keep the difference between them within about:
- Stretch-in (tackless) carpet installation over cushion relies on gripper strips at the room perimeter. When placing those strips, the pins should point:
- Solid strip hardwood is being blind-nailed. The fasteners are typically driven at roughly a 45-degree angle:
- A moisture-sensitive engineered wood floor will be installed over a radiant-heated slab. To protect the flooring, the surface temperature of the floor is generally kept below about:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra