Finish TradesCâu 285 / 700
Glazing in the wall of a bathtub or shower enclosure is a hazardous location. Safety glazing is required where the bottom exposed edge of the glazing is less than ____ above the standing surface.
a.18 inches
b.36 inches
c.60 inches
d.84 inches
Giải thích
Glazing in tub and shower walls is a hazardous location requiring safety glazing when its bottom edge is less than 60 inches above the standing or drain surface, because a wet, slippery occupant could fall against it. 18 and 36 inches understate the regulated zone, and 84 inches overstates it.
Trích dẫn luật: 2025 CA Residential Code §R308Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- In a bathroom that will receive paint (not tile), which gypsum board is a better choice for the walls and ceiling than standard board?
- On the interior of an attached garage, gypsum board fasteners into the ceiling of a garage with habitable space above are spaced to help the assembly perform. The garage-side board must generally be at least 5/8-inch Type X when there is living space above, MAINLY to:
- In a suspended acoustical ceiling grid, the perimeter of the grid is supported by wall angle (edge molding). Where main runners and cross tees are cut at the walls, they should:
- A prehung interior door binds and does not latch after installation. The MOST likely finish-carpentry cause is that the door frame was:
- At an accessible interior door, the maximum force to push or pull the door open (not counting fire doors) is generally:
- Glazing adjacent to stairways and landings is a hazardous location. Such glazing generally requires safety glazing when it is within 36 inches horizontally of the walking surface and the exposed bottom edge is less than ____ above the plane of the adjacent walking surface.
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra