Finish TradesCâu 286 / 700
A prehung interior door binds and does not latch after installation. The MOST likely finish-carpentry cause is that the door frame was:
a.Set out of plumb or the hinge/strike jamb was not shimmed straight
b.Painted with the wrong sheen
c.Fitted with a lever instead of a knob
d.Made of solid wood instead of hollow core
Giải thích
A prehung door that binds or won't latch usually was hung out of plumb, with jambs racked or unshimmed, so the door and strike no longer align. Paint sheen, lever versus knob, and door core material do not cause binding and latch misalignment.
Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- On the interior of an attached garage, gypsum board fasteners into the ceiling of a garage with habitable space above are spaced to help the assembly perform. The garage-side board must generally be at least 5/8-inch Type X when there is living space above, MAINLY to:
- In a suspended acoustical ceiling grid, the perimeter of the grid is supported by wall angle (edge molding). Where main runners and cross tees are cut at the walls, they should:
- Glazing in the wall of a bathtub or shower enclosure is a hazardous location. Safety glazing is required where the bottom exposed edge of the glazing is less than ____ above the standing surface.
- At an accessible interior door, the maximum force to push or pull the door open (not counting fire doors) is generally:
- Glazing adjacent to stairways and landings is a hazardous location. Such glazing generally requires safety glazing when it is within 36 inches horizontally of the walking surface and the exposed bottom edge is less than ____ above the plane of the adjacent walking surface.
- A sloped glass skylight over an occupied space uses glass glazing. For occupant safety against falling glass, the glazing is generally required to be:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra