Framing & StructuralCâu 386 / 700
Traditional three-coat stucco applied over metal lath on a framed wall should have what approximate MINIMUM total nominal thickness measured from the face of the lath?
a.7/8 inch
b.3/8 inch
c.1/4 inch
d.1 1/2 inches
Giải thích
Three-coat stucco (scratch, brown, and finish coats) is built to a nominal total thickness of about 7/8 inch measured from the face of the lath. 3/8 and 1/4 inch are far too thin for a three-coat system, and 1 1/2 inches is thicker than standard and unnecessary.
Trích dẫn luật: 2025 CA Residential Code §R703.7Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- For a conventionally framed wall anchored to a concrete foundation, anchor bolts of at least 1/2-inch diameter must generally be spaced no more than what distance on center?
- In a wood-framed shear wall resisting seismic loads, what is the PRIMARY function of a hold-down device installed at the wall ends?
- When applying three-coat Portland cement plaster (stucco) over wood framing on an exterior wall, a weep screed must be installed at the foundation plate line at least how far above the earth?
- To resist lateral separation of an exterior wood deck from the dwelling during seismic or live loads, which connection is the BEST practice at the ledger-to-band-joist interface?
- How many board feet are contained in ten framing members that are each 2 inches thick, 6 inches wide, and 12 feet long?
- In high-wind and seismic regions, what is the MAIN purpose of installing metal framing anchors (hurricane or seismic ties) connecting each rafter or truss to the top plate?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra