Core TradesCâu 4 / 700
The PRIMARY purpose of an isolation (expansion) joint around a column or against an existing wall in a slab-on-grade is to:
a.Let the slab move independently of the column or wall without cracking
b.Transfer bending loads directly into the column base
c.Create a decorative pattern in the finished surface
d.Serve as the location where fresh concrete bonds to hardened concrete
Giải thích
An isolation joint fully separates the slab from a fixed element so each can move independently, preventing restraint cracking. It is not meant to transfer load, is not primarily decorative, and a bonded interface is a construction joint, not an isolation joint.
Trích dẫn luật: 2025 CA Building Code (CBC) Chapter 19 (Concrete)Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A concrete mix is batched with 620 pounds of cement per cubic yard. To hold the water-cement (w/c) ratio at a MAXIMUM of 0.45, what is the greatest amount of water that may be used per cubic yard?
- An accelerating admixture such as a non-chloride accelerator is added to a concrete mix PRIMARILY to:
- During hot-weather placement with a long haul time, a set-retarding admixture is used mainly to:
- A construction joint in a concrete structure is BEST described as:
- Which curing method retains moisture in fresh concrete by forming a sealing film on the surface after finishing?
- A No. 5 reinforcing bar has a nominal diameter of 5/8 inch. If the specified tension lap splice is 40 bar diameters, what is the MINIMUM lap length?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra