Core TradesCâu 7 / 700
A No. 5 reinforcing bar has a nominal diameter of 5/8 inch. If the specified tension lap splice is 40 bar diameters, what is the MINIMUM lap length?
a.About 15 inches
b.About 20 inches
c.About 25 inches
d.About 30 inches
Giải thích
Lap = 40 x 5/8 in = 40 x 0.625 = 25 inches. Using 24 or 32 bar diameters would give 15 or 20 inches, and 48 diameters would give 30 inches, so only 25 inches matches the 40-diameter requirement.
Trích dẫn luật: 2025 CA Building Code (CBC) Chapter 19 (Concrete)Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- The PRIMARY purpose of an isolation (expansion) joint around a column or against an existing wall in a slab-on-grade is to:
- A construction joint in a concrete structure is BEST described as:
- Which curing method retains moisture in fresh concrete by forming a sealing film on the surface after finishing?
- For a typical residential interior slab-on-ground, what is a common MINIMUM slab thickness?
- When placing concrete in cold weather, fresh concrete must generally be protected from freezing until it reaches a compressive strength of at least about:
- During hot-weather concreting, plastic shrinkage cracking is BEST prevented by:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra