Framing & StructuralCâu 443 / 700
For a wood structural panel shear wall to develop its rated capacity, how must the panel edges be treated where sheets meet?
a.Edges may be left unsupported as long as the field is nailed
b.Only the top and bottom edges need backing
c.All panel edges must be backed by framing or blocking and nailed
d.Panels should be gapped and left unfastened at vertical joints
Giải thích
Shear is transferred through fastened panel edges, so every panel edge must bear on framing or blocking and be nailed at the required spacing. Leaving vertical edges unsupported or unfastened, or backing only top and bottom, breaks the load path and drastically reduces the wall's shear capacity.
Trích dẫn luật: 2025 CA Residential Code §R602.10Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A common rafter must span a horizontal run of 8 feet and rise a vertical height of 6 feet from the top plate to the ridge. Ignoring overhang, what is the approximate line length of the rafter?
- At the ends of a wood-framed shear wall, a hold-down device anchored to the foundation is installed primarily to resist which force?
- For a conventional sill-plate anchor bolt set in a concrete foundation, what is the MINIMUM embedment depth of the bolt into the concrete?
- Exterior wood siding, sheathing, or trim that is NOT preservative-treated or naturally durable must generally be kept at least how far above exposed earth?
- On a wood-framed wall receiving exterior cement plaster (stucco), a weep screed must be installed at the base of the wall at a MINIMUM of how high above adjacent earth and above paved surfaces?
- When metal lath is applied to a wood-framed wall to receive three-coat cement plaster, the lath fasteners should penetrate the framing members by at least approximately how much?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra