SafetyCâu 529 / 700
A lane closure is set up on a higher-speed roadway. According to California MUTCD principles, what is the FIRST element a driver should encounter approaching the work zone?
a.An advance warning sign area alerting drivers before the transition
b.The flagger standing in the closed lane
c.The end of the work area
d.The parked equipment with no signs
Giải thích
A temporary traffic control zone is laid out in order: an advance warning area, a transition (taper) area, the activity area, and a termination area. Drivers should FIRST meet advance warning signs that give time to react before the taper narrows the lane. Option a is correct. Encountering a flagger (b), the work area (c), or equipment (d) with no advance warning gives drivers no time to slow and merge safely.
Trích dẫn luật: California MUTCD 2014, Part 6Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Workers on a jobsite are exposed to loud equipment noise throughout the shift. At approximately what average noise level does Cal/OSHA require a hearing conservation program to begin?
- Spoil (excavated soil) is being placed next to an open trench. Where should the spoil pile be kept to reduce cave-in risk?
- A general contractor holds a weekly toolbox safety meeting. What is the PRIMARY safety-program benefit of documenting these meetings and near-miss reports?
- A worker will enter a below-grade vault that may contain low oxygen or toxic gas. What is the BEST practice before entry into this permit-required confined space?
- A worker will use a personal fall arrest system tied to a single anchor point. What is the MINIMUM anchorage strength Cal/OSHA generally requires per attached worker?
- Under Cal/OSHA heat illness prevention rules for outdoor work, at approximately what temperature must the employer make shade available upon request and when workers take breaks?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra