Core TradesCâu 94 / 700
A vent terminating through the roof must extend a minimum height above the roof and be set back from any vertical surface or opening, MAINLY to:
a.Improve the roof's appearance
b.Reduce the pipe cost
c.Keep sewer gases away from windows and prevent blockage from snow or debris while allowing free air flow
d.Support the roof structure
Giải thích
Roof vent terminations are set at a minimum height and distance from openings so escaping sewer gases disperse away from windows/air intakes and so the opening stays clear of snow and debris, maintaining venting airflow. Appearance, cost, and structural support are not the purpose.
Trích dẫn luật: 2025 CA Plumbing CodeLuyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- An island sink uses a special loop vent because there is no adjacent wall to run a conventional vent up through. This island (loop) vent works by:
- A contractor plans to join copper tubing to galvanized steel pipe directly. The BEST practice to avoid a common failure is to:
- CALCULATION: A vertical drainage stack must accommodate horizontal branch offsets. A trap arm for a 2-inch fixture drain is allowed a maximum developed length. If the code table permits 8 feet for a 2-inch trap arm, and the layout requires 11 feet to the vent, the installer should:
- A gas furnace is installed in a small, tightly sealed closet with no combustion air openings. The MOST likely dangerous consequence is:
- CALCULATION: A common rule of thumb provides 1 square inch of combustion air opening per 1,000 Btu/h of appliance input when air comes from inside a large space. For a 100,000 Btu/h furnace using two openings (high and low), what free area does EACH opening need under this rule?
- A large commercial kitchen exhaust hood removes a high volume of air. Without makeup air, the space goes into strong negative pressure. The BEST solution is to:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra