An toànCâu 472 / 521
For electrical work, a hard hat should be:
a.Class C (conductive/vented) for better airflow
b.Class E, tested to protect against electrical contact up to 20,000 volts
c.Any bump cap will do
d.Class G only, tested to 1,000 volts
Giải thích
Class E (electrical) hard hats are dielectrically tested to protect against contact up to about 20,000 volts, making them the correct choice for electrical work. Class C is conductive and unsafe near electricity, a bump cap offers little impact protection, and Class G (about 2,200V) provides far less electrical protection than Class E.
Luyện miễn phí toàn bộ 521 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Class 00 and Class 0 rubber insulating gloves are rated for maximum AC use voltages of approximately:
- When an arc-flash risk assessment requires it, in addition to arc-rated clothing a worker must protect the face and head with:
- Standard electrical arc-flash PPE also includes head and hearing protection because:
- Immediately after you open a disconnect switch, all the conductors on the load side should be treated as:
- On de-energized conductors or equipment where accidental re-energization or induced voltage is possible, workers protect themselves by applying:
- In a dwelling, 125-volt 15- and 20-ampere receptacles must be GFCI-protected in which of the following groups of locations?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-10 Electrical Trade Examination · Quy trình kiểm tra